Time Constant τ “Tau” Formulas for RC, RL & RLC Circuits
Time Constant τ “Tau” Equations for RC, RL and RLC Circuits
Time constant also known as tau represented by the symbol of “τ” is a constant parameter of any capacitive or inductive circuit. It differs from circuit to circuit and also used in different equations. The time constant for some of these circuits are given below:
τ for RC Circuit:
In this circuit, resistor having resistance “R” is connected in series with the capacitor having capacitance C, whose τ “time constant” is given by:
τ = RC
τ = RC = 1/2πfC
Where
- τ = RC = is the time constant in seconds
- R is the resistance in series in ohms (Ω)
- C is the capacitance of the capacitor in farads
- fC = cutoff frequency in hertz
τ for RL Circuit:
Inductor of inductance “L” connected in series with resistance “R”, whose time constant “τ” in seconds is given by:
τ = L/R
Where
- R is the resistance in series
- L is the Inductance of the Inductor
Universal time Constant “τ” Formula
Change = Final – Start (1 – 1/et/τ)
Where:
- Final = Value of calculated variable after infinite time (Ultimate value)
- Start = Initial value of calculated variable
- e = Euler’s number (≈2.7182818)
- t = Time in seconds
- τ = Time constant for circuits in seconds
Related Post: Analysis of a Simple RL Circuit with AC and DC Supply
τ for RLC Circuit:
In RLC circuit, we have both RL and RC time constant combined, which makes a problem calculating the time constant. So we calculate what we call the Q-Factor (quality factor).
τ for Series RLC Circuit:
τ for Parallel RLC Circuit:
Where
- R is the resistance in series
- L is the Inductance of the Inductor
- C is the capacitance of the capacitor
Related Formulas and Equations Posts:
- Equations & Formulas For RLC Circuits (Series & Parallel)
- Basic Electrical Engineering Formulas and Equations
- Resistance, Capacitance & Inductance in Series-Parallel – Equation & Formulas
- Resistance, Conductance, Impedance and Admittance Formulas
- Basic Electrical Quantities Formulas
- Power Formulas in DC and AC Single-Phase & Three-Phase Circuits
- Formula and Equations For Inductor and Inductance
- Formula and Equations For Capacitor and Capacitance
- Operational Amplifier (OP-AMP) – Formulas and Equations
- Bipolar Junction Transistor (BJT) – Formulas and Equations
- Diode Formulas & Equations – Zenner, Schockley & Rectifier
- Electric & Magnetic Flux, Density & Field Intensity Formulas
- Magnetic Terms used in Magnetic Circuits – Definitions & Formulas
- Formula & Equations for Ohm’s, Kirchhoff’s & Coulomb’s Laws
- Voltage & Current Divider Rules (VDR & CDR) Equations
- Losses in Electrical Machines – Formulas and Equations
- DC Generator Formulas and Equations
- Power, Voltage and EMF Equation of a DC Motor – Formulas
- Synchronous Generator and Alternator Formulas & Equations
- Synchronous, Stepper and AC Motors Formulas and Equations
- Induction Motor & Linear Induction Motors Formulas & Equations
- Transformer Formulas and Equations
- Electrical & Electronics Engineering Formulas & Equations
- Electrical & Electronics Elements & Symbols
In Universal Time Constant formula, Final – Start should be (Final – Start)